Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Fast, Reliable Duct Repair & Sealing Across Highbridge
Duct repair and sealing in Highbridge almost always starts in a closet or a bathroom ceiling, not a basement. Most of the housing here is six-story pre-war walk-ups, and what people call “the ducts” is usually a shared exhaust riser serving every apartment in a stack, or the rooftop make-up air unit that feeds the whole building. We work on that equipment, and we also handle the smaller forced-air systems found in the newer and renovated units around the neighborhood. One flat price per system, agreed before work starts, before-and-after photos of your own ducts, and a satisfaction guarantee on the work. Call (855) 658-4004 and we’ll get you an estimate.
Why Highbridge Homeowners and Supers Call Air Duct Cleaning Mott Haven for Duct Repair & Sealing
Word travels along a stack. In Highbridge, the buildings around the Highbridge neighborhood share supers, managing agents and maintenance staff, so a repair done properly on one riser tends to get talked about in the next building over. That’s how most of our Highbridge work starts: a referral from someone who watched a nagging bathroom fog or a dusty register finally get fixed.
Our technicians have up to 13 years of experience, and they work with contractor-grade equipment, not shop vacuums. We use Rotobrush rotary-brush systems and Nikro negative-pressure extraction, and we bring Abatement Technologies gear when fine particulates or contaminants call for real remediation rather than surface cleaning. Working on a two-inch riser in a pre-war shaft needs a different approach than a big rectangular trunk line, and the crew that shows up needs to understand what it’s looking at before it opens anything.
We serve Highbridge and the streets around it with fast dispatch from 7am to 7pm, Sunday through Friday. When you call, we can usually tell from a few questions whether you’re looking at a shared riser problem or something inside your own unit.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Our Duct Repair & Sealing Services in Highbridge
Here’s what we actually do when we’re inside a Highbridge building. The scope changes depending on whether it’s the shared stack or an in-unit system, and we’ll tell you honestly which one you’re dealing with.
Duct Sealing
Sealing is usually the fix, not a full rebuild. In Highbridge’s pre-war buildings, the riser joints above the ceiling line separate or corrode, so the exhaust fan ends up pulling air from the shaft instead of your bathroom. We seal those failed joints so the fan does the job it was installed for.

Metal Duct Repair
The galvanized elbows in an old stack take a beating. Decades of lint, grit and moisture turn pinholes into open seams, and a fan keeps running while half the air leaks into the wall cavity. Metal duct repair closes those failures and restores the run so the system moves air the way it should.

Mastic Sealant
Mastic is what holds a repair together over time. It’s a brushed-on sealant that bonds to metal and stays put through the seasonal cycling that hits Highbridge’s buildings, where radiator heat in winter and a hot, dense summer push the same ductwork through big temperature swings. Taping isn’t a substitute for mastic on a riser you won’t see again for years.

Duct Insulation
Rooftop equipment and any duct runs that pass through unconditioned space lose heat or cooling before the air ever arrives. Insulating those runs cuts the loss and stops condensation on cold metal. On a shared exhaust line, proper insulation also keeps the motor from working harder than it needs to.
Because we handle cleaning, sealing, HVAC work, dryer vent service and air quality under one roof, the same team can walk a building from intake to register. That matters here. A sealing job done on top of a dirty stack just traps the problem in place, so we clean and filter first, then seal. That full scope is what our duct repair & sealing team is built for.
Trusted Brands We Service in Highbridge
If your building’s equipment runs on Honeywell or Aprilaire controls and filtration, our technicians work with those platforms fluently instead of working around them. We also use Rotobrush rotary-brush cleaning and Nikro negative-pressure extraction for the ducts themselves, and Abatement Technologies IAQ tools when the work calls for fine-particulate or contaminant handling. We don’t stock parts on a truck and we won’t tell you we do. The pro who inspects your system reads the actual equipment, then gets what’s needed for the job, which keeps the turnaround honest. No hand-offs to a second contractor halfway through.
Common Duct Repair & Sealing Problems We See in Highbridge Homes
- Separated and corroded riser joints above the ceiling line. In older stacks, the joints pull apart or rust through, so the exhaust fan draws air from the shaft instead of the apartment. Moisture lingers in the bathroom even with the fan running full tilt.
- Rooftop fan units left open after a motor or belt swap. Make-up air and exhaust units serving the whole building are rarely re-sealed once they’ve been serviced. Open flanges bleed air and quietly undermine the system for every apartment below.
- Window ACs and radiator heat loading the registers. Dense urban heat island summers and a long pollen season pull street grit into window units, while radiator heat in winter dries the air and sends fine dust settling into common areas. Sealing over that debris without source removal just pushes it back into the room.
- Shared shafts nobody wants to open. A single-unit call in a tenement often turns into a building-wide decision once it’s clear the whole stack has the same problem. Sorting out super access and tenant coordination is part of the job, not an interruption to it.
See the difference
Before
After
Before
After
Before
AfterPricing for Duct Repair & Sealing in Highbridge, NY
Whole-system pricing in Highbridge runs roughly $450-$1,400 for a single stack or in-unit sealing and repair job, depending on how many joints have failed and how much access coordination it takes. Rooftop make-up air and exhaust unit sealing usually runs $600-$1,800 because of the equipment and the access. A smaller metal duct repair inside one unit typically lands between $250 and $700. Mastic sealing on a short run is on the low end; insulating a long exterior run is on the high end. Every price is set per job by a written estimate after we’ve actually looked at the system, so you know the number before anyone starts. Call (855) 658-4004 for a free estimate.
We Also Serve Cities Near Highbridge
The same crew and the same equipment cover the buildings just past our Highbridge routes. If you’re in Concourse, Morrisania, Washington Heights or University Heights, the work is the same shape: older walk-ups, shared risers, rooftop units that haven’t been sealed since the last service. Tell us which building and we’ll get an estimate on the schedule.
Serving Highbridge, NY – Our Local Coverage Area
We serve Highbridge and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Duct Repair & Sealing in Highbridge
It’s usually a duct problem, not the fan. In older Highbridge walk-ups the fan is often fine while the riser joints above the ceiling line have separated or corroded, so the fan pulls air from the shaft instead of the bathroom. A camera inspection of the stack settles it. Call (855) 658-4004 for an exact quote, and estimates are free.
Sometimes, but rarely in a way that fixes the symptom. Because the riser is shared, sealing one segment often just moves the leak up or down the stack, and a proper diagnosis usually shows the same failure at every apartment that feeds it. We’ll tell you what we find before anything gets scoped. Call (855) 658-4004 for an exact quote, and estimates are free.
It means checking the unit and its flanges under negative pressure, then sealing open joints that were never re-closed after a motor or belt replacement. Those gaps bleed air for the whole building, so the fix is at the rooftop, not in any one apartment. Call (855) 658-4004 for an exact quote, and estimates are free.
Cleaning removes what’s inside the duct; sealing closes the gaps that let air escape or draw in from the wrong place. Dusty registers usually point to a cleaning need first, while a fan that runs but doesn’t clear moisture points to sealing. We inspect and do both in the right order. Call (855) 658-4004 for an exact quote, and estimates are free.
Because something is still pulling debris in, and that’s almost always an unsealed joint or a leaky flange. In Highbridge’s buildings, street grit and dry winter air feed the problem, and a leak at a riser elbow or rooftop unit keeps resupplying it. Sealing closes the path. Call (855) 658-4004 for an exact quote, and estimates are free.
Get an Estimate on Your Highbridge Duct Repair
If your bathroom fan isn’t clearing moisture, your registers keep collecting dust, or a rooftop unit hasn’t been sealed since its last service, we can look at it and tell you plainly what needs fixing and what it costs. One flat price per system, agreed before work starts. Before-and-after photos of your own ducts. Satisfaction guaranteed. Call (855) 658-4004. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Air Duct Cleaning Mott Haven.